Tutorial: Embroidered “knit” heart

title

I wanted a design for the front of a knitting notebook and after doodling a few different ideas, I came up with this sweet heart. The embroidered chain stitch resembles knitting when they’re put right next to each other, so it was the obvious choice for a knitting notebook. Here are some instructions for making your own little heart!

01materials

Materials
-a tool to make small holes in paper; I use this Martha Stewart Screw Punch (affiliate link), but you could use a sharp needle + something to “hammer” it or an awl
-pencil
-about 3 yards of worsted weight yarn
-yarn needle that will fit through the holes you make
-graph paper (the paper I used is 5 squares per inch)
-card stock or whatever you want to embroider your design on

The Design

02pattern

I used graph paper to plot out my design evenly. Place the graph paper with your design on the card stock where you want to place your stitches. Use the screw punch or awl to punch holes (you’ll want to put a self-healing cutting mat, or other board you don’t care about indenting, under your paper). The holes will aid you in keeping the chain stitches straight. If you are already an embroidery master, you can probably freehand them!

On the other hand, if you have never embroidered the chain stitch, I have outlined the steps below:

embroidered chain stitch step by step via goodknits

1. Bring about half of the yarn through the bottom center hole from back to front.
2. Go back through from front to back in the same space, but do not pull the yarn all the way through.
3. Come back up through the next hole up AND through the first loop you made.
4. Pull the yarn all the way through, tightening the first loop/stitch.

Repeat steps 2-4 for the embroidered chain stitch. I got into a habit of making two loops and using the second loop to tighten the first, like this:

05-alt

At the end of the column (and the rest of the columns), finish the stitch by going down into the same hole, over the last loop, instead of through it, like this:

06-endcolumn

To make the next column, weave the yarn through the back of the stitches toward the bottom:

07-backweave

Work the next column and continue until all columns on this half of the heart are complete.

08-startcolumn2

Weave in this end of the yarn through the back of the stitches:

10-backhalf

Use the other half of the yarn to work the second half of the heart. Weave in your yarn when you’re done and that’s it!

embroidered knit heart animation

Here is my [handmade] notebook:

knitlovenotebook

I filled it with knitter’s graph paper and stitched it up by hand. That screw punch I linked above REALLY comes in handy for projects like this!

You could use this tutorial to make a lovely Valentine’s Day card! You can make other designs, as well, just be sure to have at least two dots per column when you are plotting it out on graph paper. I want to do a set of scissors! If I can come up with a few designs, I’ll make another post to share!

knitlovenotebook2

Pin It

16 comments to Tutorial: Embroidered “knit” heart